Hydraulic pump question

[firehawk7]

I built this to make a rollcage for my Bronco. Still need to get the hydraulic lines for it.


http://i48.photobucket.com/albums/f201/firecat7/100_0536.jpg

http://i48.photobucket.com/albums/f201/firecat7/100_0538.jpg





Ok now ready for hydraulic lines and I have this on my pump

The model number is Yuken DSG-01-3C60-024-5090

What is it and can I use it instead of the 4 way valve?

The part on top of the pump.

I looked it up and it is an electronically controlled valve.
I need to know if I should take it off or if I can use it.


This is the info I found for it. http://www.yuken.org/Brochures/DSG-01-70_Series.pdf

http://i48.photobucket.com/albums/f201/firecat7/100_0543.jpg
http://i48.photobucket.com/albums/f201/firecat7/100_0541.jpg
http://i48.photobucket.com/albums/f201/firecat7/100_0542.jpg

[Chestrockwell]

That will work fine, but you might want a flow control. It will be full on full off when you hit the button. Yuken makes a flow control that will fit under the solenoid block with longer allen bolts. Or you can buy an external priority valve and use that.

[firehawk7]

That will work fine, but you might want a flow control. It will be full on full off when you hit the button. Yuken makes a flow control that will fit under the solenoid block with longer allen bolts. Or you can buy an external priority valve and use that.



Would I be better off just using the 4-way valve I have and take that off?

That is probably what I will do but thanks for the reply.

I did not think about the flow control, unless I want to digitize(if that is the right term for it) it to repeat bends.

[firehawk7]

Here it is all done.

http://i48.photobucket.com/albums/f201/firecat7/100_0553.jpg
http://i48.photobucket.com/albums/f201/firecat7/100_0552.jpg



Built it to make a cage and tube doors for this. 1971 Bronco.
http://i48.photobucket.com/albums/f201/firecat7/100_0547.jpg