OK...

The axles are in the freezer!

and tomorrow, I'll heat the rings to 400 degrees!!

anyone heard of this install??

heard they'll practically drop on there...maybe might need a few hits with a mallet?

I have a press...but no dies that would ever fit the birfield joint.

These are stock birfields and North Coast Rings (forget who makes these?)

Tips??
Does the above work??

There made By Breeze and thats How I did Mine Just
make sure you put them on the right direction cause once there on what bitch to get off had a freind do his and he put them on backwards what ass...

yea...

I would assume the chamfered end goes outboard towards the wheels!

I think your over thinkin it here....

if you got a press, you should have some scrap steel or somthing. I think I used a cheep piece of muffler tube and some scrap steel at the bottom to hit on the rings as i pressed. THey went on real easy, easier than bearings and stuff...

fwiw... i went to the parts store when i got my press and bought a bunch of misc. sizes of miffler pipe with various id/od ends ~10" long, and use em all the time... (not for everything)

-yag