|
Ba-Riedo 08-02-2008, 12:46 AM My friend told me he could get a built 44 HP front from a early bronco that has a drivers side drop and a width of 60 inches... True or false? I thought the early broncos came with a LP44. -Alex wyldstallyn73 08-02-2008, 01:38 AM Depends on what you define as "built" There was never a FACTORY high pinion in the 66-77 Bronco. Doesnt mean that one couldn't be "BUILT" by narrowing up a fullsize high pinion housing. 45acp 08-02-2008, 11:09 AM They all came with LP, no factory HP. However, its been common through the years to chop a fullwidth HP axle down to 60" and run it in EB's. PhantomEB 08-03-2008, 06:30 PM Yup I have chopped up one already, and kept a 77 HP44 from a F150 to do the same again. Ba-Riedo 08-03-2008, 11:43 PM I know people chop them, he was under the impression that it was a stock width HP unit from a early bronco. Thanks for the info. -Alex broncdawg 08-04-2008, 08:57 AM Leave them full width and go Big. PhantomEB 08-04-2008, 09:39 AM I choppin mine up due to tight timber crawlin trees. holdmanbronco 08-04-2008, 06:00 PM keep them full and like said just go bigger you know you are going to some time or later, better sooner then later. This is my new plan since I checked it out, I will gain a lot from full width. AS WILL YOU!!!(from full widths) KEEP IF WIDE!! One mans view Treavor | |