from top of wheel wells to top of bow (over your head). want the cage to replace the bow on my new project. thanks.

OEM bows or the bows that are for like BestTop's, TigerTop's, etc????

funny you bring this up I was looking at my roll bar this morning wondering about doing the same----chris

for modern aftermarket top.

I'll try and get a measurement for you today---chris

main bow in the middle from the floor to the top of the foam----46.5" to 46.75"
rear bow---44.5" to 44.75"

width was like 50.5" if you need that---let me know of you need more----chris

thanks, that is a lot of help! got the seats yesterday, will need to cut the rear fender well back 2" and the front lip of the back floor back 2". i'll start drawing up the cage now.

I just re-read your requests and you wanted the measurement from the wheel wells, but I took it from the floor(lowest part of floor, not the raised rib)--just want to make sure you understand that so that your cage isn't an abortion----glad to help----chris

thanks, chris. the floor you measured from is the "bed" or in front where it drops about 5". thanks, tom.

measured from the bed right behind the front seats---chris

thanks again.