|
cbwymore 07-31-2002, 01:27 PM I'm building my perches for a spring over on my YJ and couldn't find any suitable 2.5" stock in the scrap pile. Is there any problem using 2" wide perches with 2.5" springs? The 2" perch would also solve the issue of grinding or using a offset perch on the D30 front (I know). I searched and found lots on making them, just didn't know if this would be an issue. HighHooder 07-31-2002, 02:19 PM you're going to let a 1/4" of spring hang over each side of the perch???:eek::eek: you'll be fine;) thejunker 07-31-2002, 03:24 PM I am running 2.5" wide springs on the original 2" perches on my CJ D30. It is sprung under currently, no problems so far... Brenner 08-01-2002, 04:18 PM I don't think it'll work. Don't ask why, I just don't think it will. ;) See you Sunday for the Rockers. JeepinDoug 08-01-2002, 08:45 PM No problems there, Im using wrangler springs on my cj aos, works fine. big bad Jeepster 08-02-2002, 04:32 AM I used to have 2.5" springs on 1 3/4" pads before I did my axle swap. You'll be fine, just make sure that your u-bolts are tight! | |