|
harley_sr 07-31-2002, 03:25 PM I got a friend that is goin gto give me a full size blazer. I belive he said that it has a dana 44 upfront. I was woundering how hard it is to put the full width axles under my 84 Toyota 4x4. I have already done a SAS on my Tacoma, so I not scared of a little work.. But what I am asking, will I run into any majior complications?? lizard lips 07-31-2002, 03:44 PM Its not that hard to do, you have to move the front hanger out 1 1/2 inches along with the shackle. Unless you skinny the axle. Also you have to make some brake lines other than that there isn't any major complications. Correct me if I'm wrong. :D DRM 07-31-2002, 03:51 PM Originally posted by 98Taco I got a friend that is goin gto give me a full size blazer. I belive he said that it has a dana 44 upfront. Just a FYI - but depending on the year of that Blazer, I am betting it has a Corp. 10 bolt in the front.... Comparapbe to a Dana 44 in strength for the most part, but does not use all the same parts as a 44 would.... harley_sr 07-31-2002, 06:07 PM Originally posted by DRM Just a FYI - but depending on the year of that Blazer, I am betting it has a Corp. 10 bolt in the front.... Comparapbe to a Dana 44 in strength for the most part, but does not use all the same parts as a 44 would.... Witch would you say I should try to stick with?? I may not even end up doing it, but I am considering it, hell I am getting the whole blazer for $100.. no motor, but still I figured what the hell. | |