Just picked up a scout ps box, and it came with one big ass pitman arm, id like to cut it "V" Grove cuts bend to the apropreate angle(s) then weld it back with some 100,000 tensil strenth high nickle content rod, what have you done?

I'm in the process of building my own now I just cut off the splined section of the orig. arm ground it all down so it was round. Then I got a piece of 3/4 in stock drilled a hole in it and pressed the splined section in. It will all be welded. Just have to bend it and drill a hole in the end for a heim.

OK, cool

Or you could buy this pitman arm I have for a bronco that will fit that box for 20 bucks to your door. Wouldnt aht be easier and safer?

It is a partsmike dropped bronco arm. No longer needed.

Tyler

how long is the arm center-to-center Ty ? how much drop ?

got any pics of it ? I don't see it on PM's website ...

- jack

What are you scared of the Binder sectio???

Go search for Pitman arms, we have a good thread with many different arms you can use.

Joe

NICE SIG....ISNT THAT SIR MIXALOT SP????

"DAM THEY ALL LOOK LIKE TYSON"

YOU GOT IT ;)

i needed my toy arm 1" shorter. i just cut out an inch and then v notched it and preheated it with a torch and then welded it back together with my mig. just to be safe i added some flat bar stock gusseting. seems to holding up fine. i know of several people who have cut and welded theirs with no problem.

Originally posted by TyTy
Or you could buy this pitman arm I have for a bronco that will fit that box for 20 bucks to your door. Wouldnt aht be easier and safer?

It is a partsmike dropped bronco arm. No longer needed.

Tyler

That's a sweet deal if it's the same arm I had. 4" drop Bronco arm. I paid $60 somtin' for mine

I say go for it if it is just a trail rig. If I had to drive it on the highway, I would not be able to get it out of my mind.