ok well i put a np205 in my 700r4 equipped blazer and everything is fine and dandy exept for the fact that a good amount of my tranny fluid is dumping into my transfercase and is slowly filling it up but i put gear oil in my case so once it gets high enough im going to have gear oil mixing with my tranny fluid what do i do!

Did you replace the seal between the transmission and the xfer case?

what do i do!

Replace the faulty seal :homer:

so yall forsure think its the seal its not something that is happening because of they arent meant to go together?

duh.....

theres a seal there for a reason. actually, there are two seals, one pointing each way.

okay ill rip it all apart again then

Good job. Report back to let us know it worked:D

ok i will but i just remembered that there is a bearing inside of my adapter i just dont remember if it was front or rear is that normal

Oh and dude, change your sig line, its kinda ghey and some dude over in the Ferd Section has the exact same sig line. Only vice versa.

Pick something else.:smokin:

Oh and dude, change your sig line, its kinda ghey and some dude over in the Ferd Section has the exact same sig line. Only vice versa.

Pick something else.:smokin:

i dont know how to do anything like computer wise i was gunn a put a cartoon of my truck but couldnt figure out how to put a pit there i also cant figur out how to put a pic as my avatar or w.e its called

another good - "tip " I suggest is to put some rtv sealant on the splines so the fluid cant "walk " threw the coupler
Best of luck
R

ok well i have everything back togethether and i put rtv sealant inbetween the coupler so im guna drive it for a bit and see what happens

Dude your sig sucks