PDA

: Question for the jeep tranny gods

Big Rich
08-01-2002, 06:54 PM
What trannies have the same bolt up pattern and sizing as the stock old 3spd jeep trannies?

Rich
jdjanda
08-01-2002, 09:09 PM
Originally posted by Big Rich
What trannies have the same bolt up pattern and sizing as the stock old 3spd jeep trannies?

Rich

How old? I have a T18 and T98 cases to compare if you post a pic. 4 different bolt patterns.

Joe
Big Rich
08-01-2002, 09:15 PM
Originally posted by jdjanda


How old? I have a T18 and T98 cases to compare if you post a pic. 4 different bolt patterns.

Joe

The jeep a 46' cj2a w/215 v-8 Buick/pontiac motor, I'm guessing the 3spd is about as old.

Rich
jdjanda
08-01-2002, 09:18 PM
Are you looking to replace the tranny or ?? I may be selling my 4wd T98 might bolt up.

Joe
Big Rich
08-02-2002, 07:05 AM
Yes I'm looking for a 4spd bolt up replacement trans.

Rich
jdjanda
08-02-2002, 10:02 AM
OK let's talk, I was looking to get about $350-$400. It is a six spline outout setup for a D20/D18 case. I have a good D20 setup for twin sticks that I can sell with it also. Currently I have a long Jeep input shaft on it now, but I have a Ford input shaft also (some marks on the input from the tranny sitting). The inside of the tranny is clean, all the teeth are in excellent condition and turns freely. I have a couple of different bearing retainers and cases that the parts can be swapped into, with the different parts I have this could be a bolt up. If you have the tranny out we could easily fit it up and find the right combo of parts. Oh and 1st is 6.4:1 :D

Joe