Maybe I've missed this....but does someone make a pinion flange
piece that you can simply mate to the common Spicer 1310ish CVs?

Jay

Any high volume drive shaft shop that deals with spicer stuff should have or be able to get one. I think pinion flanges and t case flanges are interchangeable, I run a 1310 CV and Ujoint in both my front and rear shaft on my toyota.

foothilloffroad.com:D

Thanks....dealt with the 1310 u-joints, but not the CVs.
Jay

i'd stay away from 1310 its cheesy on the yota's- Jess :D

I have been running a 1310 cv in the rear of my truck for 3 years and have had no problems it has even been ground on for severe angles along with the front shaft. I run a dana 44 in the front and have broken 2 axle Ujoints and had no problems with the drive shafts.

It all depends on how you drive-:D

try http://www.rocktaxi.com
He has a spicer flange book you can down load and probably find the part you are looking for.