PDA

: tie rod taper angle

szabotage
09-30-2008, 11:05 AM
anyone know the taper angle for FJ 80 tie rods?
peesalot
09-30-2008, 05:42 PM
Might be on the IH8MUD.com tech section or check Marlins site and forum at marlincrawler.com
cruiseroutfit
09-30-2008, 06:39 PM
1.2"/12" or 10:1
Rix86
10-01-2008, 12:44 PM
http://www.pscmotorsports.com/xku5912-12-per-foot-toyota-fj80-taper-reamer-p-649.html
orangefj45
10-01-2008, 07:04 PM
i got my reamers ( one for the 80 TREs and one for the 1-ton TREs) from snap on. they were a little more expensive than the one shown above but they have more flutes and bore pretty well.

make sure you use the reamer in a drill press or mill only. low speed and lots of oil is a good way to go.
Rix86
10-02-2008, 01:39 PM
i got my reamers ( one for the 80 TREs and one for the 1-ton TREs) from snap on. they were a little more expensive than the one shown above but they have more flutes and bore pretty well.

make sure you use the reamer in a drill press or mill only. low speed and lots of oil is a good way to go.

My idiot snap on guy said he couldn't find anything.
Oh well.
71-Cruiser
10-03-2008, 04:19 PM
My 1 ton reamer came from Snap On as well.