WTF size is the torqs that holds the clip on?

I just bought a 9051 AFOII and need to move the clip to the other side because im a lefty

I want to say a T6 but thats from memory. Will try and look tonight.

I want to say a T6 but thats from memory. Will try and look tonight.

For the record it is infact a T6...I just went to lowes and tried diffrent ones untill it fit.

I could have told you that. I have my Torx bits right here and a Benchmade in my pocket. And your ammo showed back up at my house today, it said un-shippable. That was with UPS, I may just stick it in a big box instead of just having it in an ammo container.

For the record it is infact a T6

Not bad for an old man :D

benchmade sells a little bit set that has 2 each T6, T8, and T10 bits in a little holder that doubles as a driver. Those SHOULD be the only sizes required on any benchmade. The Blue Box (http://www.benchmade.com/products/product_detail.aspx?model=981084X) I got one at a local shop for about 11 dollars.

I could have told you that. I have my Torx bits right here and a Benchmade in my pocket.

x2

In fact I think I'm going to go ahead and pull mine apart and give it a good bath/paintjob. It's looking like it's been in someones pocket for 4 years.

Your ammo showed back up at my house today, it said un-shippable. That was with UPS, I may just stick it in a big box instead of just having it in an ammo container.

Well son of a bitch...did you put an ORM-D sticker on it?

x2

In fact I think I'm going to go ahead and pull mine apart and give it a good bath/paintjob. It's looking like it's been in someones pocket for 4 years.

:laughing:

All of my DCUs have a small hole at the righthand pocket and the clip on my striker is pretty ground down from leaning against the side of the gun trucks. Only did that job for 4 months :D

Well son of a bitch...did you put an ORM-D sticker on it?

Yeah you have to declare it and have the proper labels and pay the hazmat.

or you could try sticking it into USPS flat rate boxed and send it as 'car parts'








































dont blame me when the inspector general calls you though :flipoff2:

:laughing:

All of my DCUs have a small hole at the righthand pocket and the clip on my striker is pretty ground down from leaning against the side of the gun trucks. Only did that job for 4 months :D

Perhaps this is the only reason to buy a pair of 5.11 pants. :flipoff2:

:laughing:

Don't think our CO would have approved.

:laughing:

All of my DCUs have a small hole at the righthand pocket and the clip on my striker is pretty ground down from leaning against the side of the gun trucks. Only did that job for 4 months :D At least the DCUs were somewhat durable. If I'm not careful I can wear a pair of ACU pants out in about 3 days. The newest ones I have seem to be a lot better.