I'm trying to jig up my axle tabs and coil buckets/plates wondering if some can give me a measure ment

say from the coil isolator to the top of the axle tube with appox 5 inches of lit

basically I trying to figure where the axle will be located with coils on and weighted jeep front in relation to my "frame"

thanx

From the CENTERLINE of the axle tube to the bottom of the isolater is about 19.5".

From the CENTERLINE of the axle tube to the bottom of the isolater is about 19.5".

GW to the RESCUE:smokin:

http://www.supermotors.net/getfile/677503/fullsize/picture-027.jpg
http://www.supermotors.net/getfile/677502/fullsize/picture-030.jpg
http://www.supermotors.net/getfile/677501/fullsize/picture-029.jpg

getting closer:p

You got it. Is that a 44 or a 60? I think I see kingpin but can quite tell.

91 ford kingpin