Any in the sac area? I need access to one to remove a very stuck 60 inner knuckle. It has not been welded. I think it fused when I installed it. Have maxed out a 20 ton with the heat. Nearly all tricks have been tried- just need alot of grunt. I have access to one in santa rosa but would rather not drive 3 hours if I can avoid it. Any ideas?? :beer:


edit: now how the hell do I delete these duplicate threads with no content?

Originally posted by Aggro

edit: now how the hell do I delete these duplicate threads with no content?

I took care of it for ya. ;)

If Sean can't take care of you at River City Differentials, go visit Mike at T&M Tranny -- they're both in junkard central down in Rancho.

Randii

Submerse the tube in a plugged pipe filled with liquid nitrogen and use two large rose buds on the knuckle, it will come right out. Probably with no pressing at all. I would worry about breaking stuff with any bigger press.

Brook

Just slice it with a cut-off wheel or sawzall and it will come off with a few taps. Vee it out and weld up the kerf when you weld it to the tube...takes about 2 minutes