im 16 and from reno this is my rig.
6 inch RE lift
33x12.5
started on the first day.
http://i209.photobucket.com/albums/bb6/revoracer99/CIMG0601.jpg
started the bondo and bumper
http://i239.photobucket.com/albums/ff21/huntinand4wheelin/CIMG0636.jpg
New rubbers!
before.
http://i239.photobucket.com/albums/ff21/huntinand4wheelin/CIMG0605.jpg
after
http://i209.photobucket.com/albums/bb6/revoracer99/PICT0004.jpg
my rear driveshaft angle is pretty steep 14* and it has a cv front. my question is can i put shims under my rear axle or does that mess with my joints. any critizism is welcome

bite the bullet and just get a Slip Yolk Eliminator there about 200. i would never put shims under one of my rigs ever again

:selfwhore: I got your solution right here, $200. Its a used RE SYE Hack and Tap, includes the driveshaft. Let me know if you want it, its 200 for the kit, but then you have to get a drive shaft too... :selfwhoreoff:

:selfwhore: I got your solution right here, $200. Its a used RE SYE Hack and Tap, includes the driveshaft. Let me know if you want it, its 200 for the kit, but then you have to get a drive shaft too... :selfwhoreoff:

scott you're such a whore....you naughty bitch you..