Came back from the rubicon this weekend and had bad tire wobble at about 30 mph on the front pasanger side. I am looking for ideas that might be causing this problem. The tire is sucked in at the bottom. Just installed before trip was crossover hight steer by sky-manufacturing. The housing does not look bent. We were thinking that I might be bad bearings, could that cause this. Have not had time to pull it apart yet, just looking for ideas. Thanks in advance for the help.

Check the toe-in, if that does not help check the wheel bearings, if that is not it check the Trunion (knuckle) bearings.. Make sure that the pre-load is adjusted right on both the Trunion and wheel bearings. Setting the toe-in fixed mine.:D

Originally posted by OOP'S
Check the toe-in, if that does not help check the wheel bearings, if that is not it check the Trunion (knuckle) bearings.. Make sure that the pre-load is adjusted right on both the Trunion and wheel bearings. Setting the toe-in fixed mine.:D what he said..the draglink may have come loose and changed the toe-in

Its not toed in. It is the camber. It looks toed in, if you were looking at it from under the rig. At the bottom of the tires where it hits the ground is closer than the top and it is only on the pas front tire.

Originally posted by Drunk Guy
Its not toed in. It is the camber. It looks toed in, if you were looking at it from under the rig. At the bottom of the tires where it hits the ground is closer than the top and it is only on the pas front tire. but you need to check the simple first the toein will make it off camber so i would check it first then go to the others..bad toein is the most common camber problum with toys