One of my employees has a '77 F250 8 lug ( :rolleyes: ) 44, with 5 bolt knuckle/spindles. He needs to make it high steer. It has a flat top with the proper cast in thicker section for the 9/16" studs. Has anyone done this? It seems like a waste to go to Chevy 6 bolt spindles, etc. I'm looking for someone who can mill & drill the 5 lug for him. My hook up just got promoted to the office and one off machine world wants too much $$$$$$ to do it.

In searching it seems like it has been done before but I can't find a post that actually has someone who has done it.

PM JoshC he just had some one mill and drill a Dodge knuckle for him.
Maybe he can get his done at the same place.

I have some of those too. Will Do. WTF are you doing in here following me???? :flipoff2:

Following you HAHAHA

I've been posting here off an on for a while.:flipoff2:

My damn CJ was almost going to be 45% ford until I ended up with the Buggy chassis.

Found a place we can get them done cheaply now.

Boy you ford guys sure can go through a few pages in a day or so

:flipoff2: