deleon87
08-12-2002, 10:32 PM
putting my tranny back in on my 85 22r i broke the tranny mount the one the tranny and engine bolt up to.
not only that that after i put it in it would go in to any gear cluch seamed to not work something must of went wrong when i put it back in that i didn't notice.
anyone have any of these mounts laying around?
This isn't that uncommon, especially with the older mounts. Try to get one from '87+, they are a lot beefier and they bolt right up:
http://www.yankeetoys.org/members/KLF/Taz/Xmember/Mounts.jpg
(busted '84 mount on the left, new '87 mount on the right)
deleon87
08-12-2002, 10:50 PM
no the 4 bolt mount at the bellhousing to engine mount
crash
08-12-2002, 11:30 PM
You talking about the bell housing?
deleon87
08-12-2002, 11:36 PM
Originally posted by deleon87
no the 4 bolt mount at the bellhousing to engine mount
yes there is two mounts on the lower part of the bellhousing that bolts to the engine
I think he is talking about the cast angle support bracket from the side of the eng to the bottom of the bellhousing. But i dont know how to fix the prob you have.
85TrailToy
08-13-2002, 04:01 AM
Damn, how did you break that?? I *might* have one, is it the right or left one?
I think I have them also.....I never put them back on after the motor swap.
deleon87
08-13-2002, 07:16 AM
Originally posted by 85TrailToy
Damn, how did you break that?? I *might* have one, is it the right or left one?
it's the left one
deleon87
08-14-2002, 11:59 AM
do you have to have those mounts on can you get by without them?
Ive fitted a lot of engines that run those braces and dont usually bother refitting them and have had no probs yet.