i have an 84 nissan 4x4 extended cab, i was wondering if the chevy axles would work ok with the front drive shaft angle to the passenger side the t-case is divorced and center with the truck. my nissan running gear is all stock with the exception of the chevy axles... i have a limited budget.. will this work or am i gonna bust driveshafts left and right. the rear diff on my truck is shot so thats why im using the chevy axles, 12 bolt rear a d44 up front.. all help appreaciated

What side drop is the Chevy axle? I too have a 720 and I considered dropping in a V8 and thus bigger axles, as far as I could tell you wont have much of a problem bc of how long the front shaft is. The length helps keep the angles smaller. Although you'll probably want a bigger shaft.

I dont know any of this for sure, its just my 2 cents

ive gat an 83 with wagoneer 44s under it and the stock drive shafts have to be replaced. goin with wagoneer drive shats with the nissan ends welded on.also runnin a chevy 305 and th350. ran the 350 slip yoke to a nissas end and machined a 3 inch thick piece of alum. to make up for the distance from the 350 to the devorced tcase. runnin 38.5 boggershttp://c2.ac-images.myspacecdn.com/images02/5/l_9b0f3c9c4626432fa724e8c6dd1fdb11.jpg