i need a set of ford radius arms so i can get this axle under my tacoma.

http://i270.photobucket.com/albums/jj104/motoxkfx/IMG_1149.jpg


http://i270.photobucket.com/albums/jj104/motoxkfx/IMG_1187.jpg


http://i270.photobucket.com/albums/jj104/motoxkfx/IMG_1209.jpg

put it in the wanted section, youll have better luck

I have a set here in WI...No I wont ship...

Try a junk yard...

http://www.car-part.com/

Seach there...

Also craigs list...What you can pay for a cheap Ford you can get your parts & sell the rest & make money...

Spend the money on Cage Off Road arms with the heavier frame brackets, you wont be disappointed.

i have a clean set of radius arms with the coil buckets, pm me and all see what i can do,

thanks

You can slap it under there with stock arms but you won't get he best travel till you lengthen them or get some aftermarket arms.

You can slap it under there with stock arms but you won't get he best travel till you lengthen them or get some aftermarket arms.

I am going to lengthen them 12 inches. at least that seems to be what every one is doing what is the best length to make them.

Want a set that's already lengthened and the pass side is wristed? Worked very well on my jeep for some hellatious beatings and are therefore bent several different ways. Other side is same minus the wrist. Boxed with 1/4 and the wristed(bent one) was filled with 3/8" plate prior to the 1/4" boxing. Setup for 1.25" heims or Johnny Joints. If I were to do another swap using them I'd cut em off and make brackets like the old twister arms had... Or just get a 44 without cast in wedges. The funny looking end piece is where I sleeved the 1.5 .250 wall that I tapped for the 1.25" hiems to keep the threads from distorting/pulling out.

http://www.pirate4x4.com/forum/picture.php?albumid=137&pictureid=1258

I've got a etra set I think..$75 plus shipping.PM me!!

http://i26.photobucket.com/albums/c110/MarioPortale/Krawler/100_4208.jpg

do you need bushings and the coil buckets?