tnt 3 link with frame stiffners...will it work? [Archive]

iwishihad1

01-12-2009, 12:13 PM

hey everybody

well with the 3 link, axle swap, 38s, and hitting more challenging trails, i want to start doing something about stiffening the frame. i was going to go with TNT sleeves, and TMR front plates, and probably over summer cage it. well with the RK 3 link mounts sliding up around the "frame rails" i really dont see how i could make this work?

anybody got any suggestions. maybe cut out where the RK mounts are, and just weld around it?

thanks

Preppi12

01-12-2009, 02:17 PM

maybe cut out where the RK mounts are, and just weld around it?

Sounds like you already know the answer! :)


Pirate4x4.Com > Brand Specific Tech > Jeep - Cherokee > tnt 3 link with frame stiffners...will it work? PDA : tnt 3 link with frame stiffners...will it work? iwishihad1 01-12-2009, 12:13 PM hey everybody well with the 3 link, axle swap, 38s, and hitting more challenging trails, i want to start doing something about stiffening the frame. i was going to go with TNT sleeves, and TMR front plates, and probably over summer cage it. well with the RK 3 link mounts sliding up around the "frame rails" i really dont see how i could make this work? anybody got any suggestions. maybe cut out where the RK mounts are, and just weld around it? thanks Preppi12 01-12-2009, 02:17 PM maybe cut out where the RK mounts are, and just weld around it? Sounds like you already know the answer! :)