Has 3 1410 yoke's on it and cleaned/painted for $400. What yall think? Also would this t-case be streetable(gear ranges not to low)? What yall think of this t-case(pretty much an NP200).

Thanks

1.96:1 ratio.

oiling issues at high speeds.

right hand drive rear output.

right hand front output.

should work great.

im willing to bet you can find a divorced dodge np205 for less than that, but why not get a trophy case like one out of an m37?

If ya get one from an M-37, you'll want to try to make sure your geared so you won't be spinning the input over about 2500RPM's. They seem to have a heat issue if spun faster.

you sure they are 1410 yokes? dodge used another size that is close to it but not quite on some of the older stuff.

The feller said 1410 yokes. But I got a TH400 tranny at the house im going to get rebuilt. Its a 2wd tranny and just going to get a divoriced np205 and do that. But having to replace my 350 motor(blew it up), so that will take alittle while.