This is a Kling #4 60 Ton Mechanical Iron Worker. It is a combination ironworker that can shear (plate, rounds, squares, flat bar, angles), punch, notch, and miter. The punch end works independent of the ironworking end, and is air actuated. The foot control did not come with this unit when it was acquired but is readily available. It could also be easily converted back to mechanical actuation by a simple fabricated lever. The shearing and notching end is mechanically actuated by means of a foot pedal. The machine is complete with the exception of the upper angle iron shear blade (p/n 30870) and the lower 90 degree notch dies (p/n 30875). All parts for this machine are available from www.hill-acme.com or http://www.americanpunchco.com/machine_tooling/kingsland_hillacme_kling_ironcrafter.htm .
The following are the machine specs:

· Tonnage- 60 tons

· Punching Capacity- 15/16" thru 5/8" steel plate

· Shearing Capacity: Plate-1/2", Flat Bar-5/8"X6", Round-1 ¾", Square-1 ½", Angles-4"X4"X ½", Notch-3"X3"X 5/16"

· Motor- 5hp 220v 3 phase

· Size- 72"long X 36"wide X 83" tall

· Weight- 5,000 lbs.

Included are drawings, operating manual, and parts list.


220 3 phase but you could convert it to 220 single by swapping motors.Its been completly rebuilt,stripped,and repainted.

For pick up you will need to rent a forklift to get it on your trailer.

$3000. Located in Clovis.

http://www.norcalbigdawgs.net/Gallery/albums/album243/IMG_4991x.thumb.jpg
http://www.norcalbigdawgs.net/Gallery/albums/album243/IMG_4986x.thumb.jpg
http://www.norcalbigdawgs.net/Gallery/albums/album243/IMG_4981x.thumb.jpg
http://www.norcalbigdawgs.net/Gallery/albums/album243/IMG_4980x.thumb.jpg
http://www.norcalbigdawgs.net/Gallery/albums/album243/IMG_4997x.thumb.jpg