|
: How Do I Bleed My Hydro Setup For My Bender 71RCKCRZR RYAN 08-20-2002, 09:27 PM IM SETTING UP MY BENDER FOR HYDRO. GOT A BIGASS RAM,PUMP AND VALVE. HOW DO I BLEED IT??\ DOES THE RAM NEED TO BE MOUNTED WITH THE FITTINGS FACING UP? CHOKE THE CHICKEN OR VULVA PLEASE DONT REPLY:mad: :flipoff2: :flipoff2: :D CHOKEu 08-20-2002, 09:37 PM :D :D :flipoff2: You need to suck the ram off then blow it!:flipoff2: Or is that blow the ram then SUCK IT!:flipoff2: 71RCKCRZR RYAN 08-20-2002, 09:39 PM YOUR:rainbow: :rainbow: zags 08-20-2002, 10:11 PM Yes, mount the ram with the fittings facing up. You just need to run the ram bak and forth a few times to bleed it. If the ram fittings face down, it will trap air in the cyl. John H 08-20-2002, 10:20 PM Just operate it back an fourth a bunch of time. Just watch when it burps some air. The ram can extend or retrack very quickly. Damn near took my hand off when i was bleeding mine. vova 08-20-2002, 11:02 PM I guess it's time to bend me something :flipoff2: Tell Gary to call me. I need to get the axle machines this week! | |