I just finished adapting my tubo 350 and dana 300 together. i was wondering what is the best way to build a driveshaft to work with this combo? it has to be a tiny shaft due to clearance issues with the 350 pan. someone told me that they had used an axleshaft from moser and had it splined on one end to use with the slip yoke and then welded a yoke on the other end. any ideas will be appreciated.

btt

I would suggest calling Jesse at High angle d-line and run your idea by him. I used a d44 front shaft for a d-line and it never broke, but I told that to my d-line guy and he about shit. He said it puts extreme wear and pressure on the pinion bearings and was more likely to break more parts