The Atlas my friend just bought and had the 1350 yokes installed on the front and rear outputs, and has to run a 2in. diameter front dline, but he is worried it will hit his th350 pan. He had a d60 narrowed correctly to put the yoke as far to the pass side as possible. He is still having a hard time fitting a 2in d line.Have any ideas?

I've seen people notch the tranny pan before. If it is really that bad then I would do this.

i can make you an ultra tough 1350 rockcraler shaft 1 5/8 diameter where your tight spot is- Give me a call-530-877-2875 Jess @ High Angle Driveline

Onetoncv you came to the call. I was planning on e mailing you this dillema and i will pass on your phone # and a good recommendation. Thanks.