|
cisrael 08-27-2002, 09:07 AM Swapping a D44s from an 89' Waggy to my 94' YJ. Both front an rear waggy yokes accept a 1310 U joint. Fine for the front but, my rear shaft has at 1330 since this that is was my old 35 yoke accepted. What yoke can I use on this pinion to accept a 1330? Dust Puppy 08-27-2002, 09:19 AM not quite sure what to tell you... have you thought about a confersion u joint? im running a 1310 driveshaft w/ a 1350 yoke on my 14 bolt until i get the new shaft. just a thought. GaJeep94YJ 08-27-2002, 09:28 AM put the 35 yolk on there. I have a 88 waggy in my 94 yj. I made new DS but I used the 1330 part from the 94 DS just cut it off and made a new DS with that and a front XJ DS that had a CV joint. the yolk from the D35 will fit on the D44 just fine believe it or not. also dill out the yolk so it will accept u bolt instead of straps. HTH ColoYJ 08-27-2002, 01:22 PM You guys are making it way to hard! Go down to your local junkyard and find a 44 yolk that accepts 1330 joints. They had a pile of them so I took my 35 yolk to find the right ujoint size and I took the wag44 yolk to make sure it was a 44 style. A 35 yolk will not fit. The yolk wont seal the pinion. onetoncv 08-27-2002, 08:09 PM u joint part # 5-134x - 1310-1330 stock u joint on a ford- Jess GaJeep94YJ 08-28-2002, 08:49 AM Originally posted by ColoYJ A 35 yolk will not fit. The yolk wont seal the pinion. shhhhhhhh don't tell my '88 waggy 44 that then, b/c it has been that way for more than a year with no leaks!:flipoff2: | |