Ford Dana 60 full float flanges By Branik Motorsports.
Made from 1018 billet. Manufactured to make any rear end full float and able to accept very common and available hubs and spindles.
Uses a double spline axle shaft made by Branik Motorsports( 4340 or 300M )
Xtremely strong set up.
Will machine to fit any axle tube.

--Kit includes 2 full float flanges and all Grade 8 hardware--

*Special* through May!
$240.00 To Your Door!!!

A picture of exploded view assembly

do they butt weld onto the housing? got a picture of that spot?

good call on offering these. they are an excellent option for a rear build! i have been machining ends like these for a long time but never had the forsight (or the equipment) to run a batch.

do they butt weld onto the housing? got a picture of that spot?

I'll post a pic of back side.
back is counterbored to whatever axle dia. is spec'd,
ie 3", 3.125, etc, fit in axle w/ square end, and weld
outside, and inside. Super strong! way stronger than boring
out stock d60 ff housing!
will also work on 14bolt and 9" Ford, any axle!
use std. d60 drive flanges.

Im guessing that anyone buying them would also be interested in a kit that would include shafts, slugs, and caliper brackets. It would be cool to see a one stop price to buy all the parts needed to complete the axle.

bump

ttt

Branik

tttbump