I asked this in the jeep forum http://www.pirate4x4.com/forum/showthread.php?s=&threadid=77191 but then realized that the drive shaft I amgoing to need isn't going to come from a jeep! (not strong enough)

but what I need is a cv joint for my jeep. I want either 1310 or 1350. I was only asking for 1310 but i finally found a 1350 yolk for my dana 300 in my jeep.

relevent specs: 94ish YJ, dana 300, dana 44.

I have found that I can get a pre 76 front CV joint and it would work. the only problem is there aren't many of those down here in JYs. any other suggestions? what would I look in for a 1350 joint?

no one?

I am using a front driveshaft out of a '79 F250 for my rear driveshaft it has the 1350 CV. Where did you get the 1350 yoke for the 300? HAve a part #?

Best
MT

no part number sorry. a friend of mine is giving it to me. I haven't gone and picked it up yet b/c I am not sure if I can find a DS that will work.

Bronco CV's are 1330..
Lincoln's have CV's but I dont know the size. It was big though so 1330 or 1350

Yea, lotsa broncos with 1330 Cv...get the yoke of the D44 front too.