Poly Performance Double Adjuster Tube Adapter

-The Poly Performance Double Adjuster Tube Adapter is designed to eliminate the need for jam nuts that are normally used when building link suspension systems.
-The double adjuster allows the user to fine-tune the suspension geometry of a link suspension by loosening the pinch bolt and turning the adjuster sleeve.
-Ideal for link suspension designs with weld on bushings/joints at one end or bent suspension links.
-The weld on tube adapter is made from solid stock 1018 Steel.
-The tube adapter seals the link off from water or other debris entering the link which can cause damage over time.
-An integrated drain hole lets any water that enters the threads of the adapter drain out.

Adapters Include:
-(1) Weld on Tube Adapter with Pinch Bolt Slit and Tubes
-(1) Zinc Plated Double Adjuster Sleeve to be used with 1 1/4" LH Thread Shank Rod End
-(1) 1/2" Pinch Bolt Hardware

CLICK HERE FOR MORE INFO (http://www.polyperformance.com/shop/Poly-Performance-Double-Adjuster-Tube-Adapter-p-19276.html)

http://www.polyperformance.com/shop/images/D/3620-12-1X-D2-400.jpg

http://www.polyperformance.com/shop/images/D/3620-12-1X-D3-400.jpg

http://www.polyperformance.com/shop/images/D/Double-Adjuster-Tube-Adapter-Anim.gif

I was wondering when you guys where going to release these! Great idea!

Can the inner sleeve be sized for a TRE? This would solve a lot of problems for me.

Edit: I just looked on the website and they look like they are coming...Thanks!

you still need a jam nut where the joint threads into the sleeve right?

you still need a jam nut where the joint threads into the sleeve right?

Nope, look again at the sleeve there's a slit all the way down it.

Very cool idea!

PM's sent.


Thanks for the orders!:D