ac power pack wiring ?

[hybrid-theory]

http://www.surpluscenter.com/item.asp?UID=2009051722013075&item=9-7137&catname=hydraulic
I am looking for a wiring schematic for this pump I just got. It is single phase solenoid release style pump. I was trying to take a picture of it but the camera is dead. It can be wired for high power, or low power, not sure what I should use.

Plus it has the solenoid for the return for the fluid. I tried looking thru some old threads in the "home built tubing bender thread" looking to see if anybody else had the same pump, but nothing about wiring it up. Thanks Wade.

[demonranger]

if you have 240V present I would wire it up to run off of that, a 2hp motor can run off of 110V but would be happier with 240V running longer and cooler. Keep in mind wire sizes required for the higher loads with 110V especially in extension cords.

[hybrid-theory]

if you have 240V present I would wire it up to run off of that, a 2hp motor can run off of 110V but would be happier with 240V running longer and cooler. Keep in mind wire sizes required for the higher loads with 110V especially in extension cords.

I do have 240V, but its the on/off switch and solenoid release valve wiring that has got me puzzled. I got a toggle switch I want it to work off from, and that is where its getting me confused. Thanks Wade

[hybrid-theory]

Ok still no luck with this. I need someone smarter than me to give me a schematic on how to wire this baby up. I want to wire it up 220v. I assume the high voltage is what I want right?

Here are some pics from the motor and the solenoid release valve that is stumping me the most. Thanks Wade