|
sweden 09-06-2002, 08:04 AM What kind of axle is this? It has stock vacuum controlled lockers front and rear. http://multimedia.campus.luth.se/offroad/what_axle_is_this_small.jpg http://multimedia.campus.luth.se/offroad/what_axle_is_this_small2.jpg Aggro 09-06-2002, 08:14 AM Are they ford econoline?? :flipoff2: MR4WD 09-06-2002, 08:17 AM Rockwell 5 ton? elf_cruiser 09-06-2002, 08:21 AM MR4WD is a dipshit... I don't know what they are, but they are NOT 5tons... They look cool, though, got any specs?? Eskimo 09-06-2002, 08:28 AM Originally posted by Aggro Are they ford econoline?? :flipoff2: Can't be...that's a Dodge Van... :flipoff2: You can't put axles from a Ford under a Dodge! Are you NUTS? :flipoff2: sweden 09-06-2002, 11:19 AM No ideas ? :) Trick question. -I know exactly what kind of axle it is. It's from a 50's Volvo 6x6 :) http://multimedia.campus.luth.se/offroad/volvo_934.jpg It's much like a rockwell from the looks of it. I even thought that it was the same axle. But your doesnt have lockers (DUH).. From what i heard they looked on your stuff when they constructed it. Every axle on all Swedish military vehicles are fully locked. (Except one, the volvo laplander who had dana44's and lammelldiff in the rear.) Sad picture (http://www.ludd.luth.se/users/magnush/utskrotningen/pics/scrapping_direktkontakt_stena_reportage_02.jpg) Want axles :( (http://multimedia.campus.luth.se/offroad/volvo_934_axles.jpg) MR4WD 09-06-2002, 11:27 AM I'd almost bet it used a rockwell center section, look at the assembly. It looks like a 2.5 ton housing with a 5 ton gear set. MR4WD 09-06-2002, 11:46 AM But it's black though! Aren't rockwells black? :flipoff2: :rolleyes: No, I didn't mean 5 ton dropped into a 2.5 ton axle, I meant mass produced with "off the shelf parts" using different combinations. After comparing the two, it's obvious it's not rockwell; "Looks" like a 5-ton center chunk though. At any rate, I'd like to know what years rockwell diffs were produced new? both 2.5ers and 5 toners.... Jason R 09-06-2002, 11:50 AM Originally posted by MR4WD But it's black though! Aren't rockwells black? Are you serious? Mr4WD scores again. :shaking: :flipoff2: reddwarf 09-06-2002, 03:32 PM what's a "lammelldiff"?:confused: sweden 09-06-2002, 03:56 PM Huhu, coulden't find the English word for it, it's some kind of limited slip based on discs bundled and torqued together.. Volvo laplander guys uses to put to rear into the front when it starts to slip and get a fresh one in the rear. reddwarf 09-06-2002, 04:16 PM Sounds like a regular Posi-type limited slip. RHINO 09-06-2002, 05:11 PM i know what those are, and i thought i read some time back on a euro web page about a guy who put mog portals on those centers. do you know anything about that sweden?? reddwarf 09-07-2002, 09:55 AM Originally posted by RHINO mog portals on those centers. Geez, imagine the final drive ratio :eek: TNToy 09-07-2002, 10:40 AM And the motor running six grand at 30 MPH in high range. :eek: Maine Jeepah 09-07-2002, 11:30 AM http://multimedia.campus.luth.se/offroad/volvo_934_axles.jpg OMG!!! SOMEONE SAVE THE AXLES !!!!!:flipoff2: e cliff 09-07-2002, 10:19 PM Originally posted by Maine Jeepah http://multimedia.campus.luth.se/offroad/volvo_934_axles.jpg OMG!!! SOMEONE SAVE THE AXLES !!!!!:flipoff2: you said it:( sweden 12-05-2002, 05:04 PM Have been looking into buying a set of these swe rockwell lookalikes. -Checked with a finnish company that currently are fragmenting some leftover trucks and they wanted 250$ for a front and 200$ for a rear. Think i'm going for two fronts. It's not settled just yet, but there might be pictures at the very least sometime in the future :) Rockwells are not the most common things around my area :) XtrmChevy 12-06-2002, 02:35 AM Yo! Finnish company? So what company would that be? | |