YouTube - Fort Nelson '09 mud bog (http://www.youtube.com/watch?v=MqmlVwi7M2g)

that sammy has always cracked me up, a rotary (i assuming) spinning 10k+ will confuse the hell out of anybody lookin and listening, that and the fact it turns them 35x16 boggers with ease (well once you hit the powerband), so spill it anything special about the powerplant??

YouTube - Fort Nelson '09 mud bog (http://www.youtube.com/watch?v=MqmlVwi7M2g)

that sammy has always cracked me up, a rotary (i assuming) spinning 10k+ will confuse the hell out of anybody lookin and listening, that and the fact it turns them 35x16 boggers with ease (well once you hit the powerband), so spill it anything special about the powerplant??

Noooo kidding :laughing: It sounds like a pissed off weedwacker but it sure as hell gets the job done.

Holy balls that thing is wicked. Ok spill the beans.

Ya that little guy can go eh.

Id assume 13B 2 rotor, probably street ported, non turbo...

Haha thats awesome! :grinpimp:

sure sounds good up on the pipe.

HAHA I had to register first, haven't really been on here before!!

The suzuki is my father in laws rig, we transplanted a 12A rotary from an early 80s RX7, we added a holley street port intake, 465 holley 4 barrel carb and a home built header. We estimate that we've hit about 11500rpm+ with it on a few occasions. He is running 33x14 boggers, offset rims, a 4.6- something gear ratio, spool in the rear, 5 speed trans from the RX7 with a divorced suzuki tcase. We found an auto trans for it that we may throw in once its built to handle his right foot. The only issue we have with it is the short wheelbase. Its damn hard to keep it straight in the pits. We plan to either extend the wheelbase, or gut a mini truck and throw in the rest of the drivetrain. The best part is the whole rig was built for under $3000

Now I know what to do with my streetported 12a.:smokin:

throw in a turbo after the carb.

Its a good video :) and not just because I kick butt in it too LOL....