|
MX489 07-10-2009, 04:54 PM Tearing down the 44 and I cannot get this snap ring off for the life of me. It is the diameter of the hub. I found the seperation but there are no little holes to grab onto or anything like most rings. I have articles on teardown as well as a haynes manual and of course they all skip right over this ring and just say "remove" it. Any tips? jeepcj 07-10-2009, 05:34 PM I've used a mini flat screw driver in the past to dived and then grabbed the close end with a small needle nose plier zainyD 07-10-2009, 05:43 PM Get set of picks and use them or find an unloved, small flat head screwdriver and bend the tip so that it looks like a little scoop. Check out Mr. N's D44 site, he has detailed teardown instructions with pictures on there for ya. Mr.N 07-10-2009, 05:51 PM Get set of picks and use them or find an unloved, small flat head screwdriver and bend the tip so that it looks like a little scoop. Check out Mr. N's D44 site, he has detailed teardown instructions with pictures on there for ya. Thanks for the plug. Link in sig MX489 07-10-2009, 07:19 PM Get set of picks and use them or find an unloved, small flat head screwdriver and bend the tip so that it looks like a little scoop. Check out Mr. N's D44 site, he has detailed teardown instructions with pictures on there for ya. Thanks for the plug. Link in sig Very helpful, thanks Mr.N 07-10-2009, 07:43 PM Very helpful, thanks Glad it helped! Some day I'll update it with much better pics... | |