NEW Ballistic Rod Ends VER. 2.0


Now choose from 3/4", 5/8", or 9/16" bore.


http://www.ballisticfabrication.com/assets/images/rodends/bremrk2b.jpg

http://www.ballisticfabrication.com/assets/images/rodends/bremrk2a.jpg


Introducing our newest in high performance suspension, the 4340 Billet Ballistic Rod End delivers the best. Offering 70 degrees of misalignment and a rebuildable bearing race, these joints will outlast the traditional rod end.

Why choose these joints over traditional rod ends?

First and most obvious, these are rebuildable for only a fraction of the cost of a 1.25" heim. These are machined from billet heat treated 4340. You won't find many mainstream manufacturers that will tell you what their "alloy" rod ends consist of. A lot of manufacturers do not machine from billets, they are finished from forgings, and nearly all of them begin life in China. The Ballistic Rod Ends are a true grease-able joint that is not metal/metal. That means longer life and a quieter joint. We incorporate a 3.5" shank, about 1.25" longer than any heim on the market today. Last, these are 100% made in the USA from USA derived raw product.


Machined from Billet 4340 pre-treat steel
100% rebuildable using solid nylatron races
1.25" shank standard
9/16", 5/8", and 3/4" bores available, all with 2.625" mounting width
+/- 35 degrees of total movement with a 9/16" ball.
Bearing machined from 4130 then hard chrome plated
MIL-SPEC grade, in use on prototype military vehicles currently
100% made in the USA!

Check them out here
http://www.ballisticfabrication.com/Billet-Ballistic-Rod-End_p_1655.html#

You have my attention. Unbelievable products, but this one takes the cake.

My order will be coming soon.

Thanks for all the great stuff in the past.