I have a 19 inch from center of t-case output to center of pinion. This driveshaft ha a 1310 ujoint on the case side and a 1330 u-joint on the pinion side for a full-width axles.

I got this as a kit with my SYE and now I am lengening my jeep by over 6 inches. My loss is by far your gain. I will take $200 or best offer.

PM me for more info.

Located near Louisville, KY

I forgot to ask again, sorry. But do you know if you got the S spline or X spline? Also I take it this is a CV Driveshaft for the rear right? Sorry if these questions are pretty stupid