i need the width of 2 differant axles, the first is a narrow track waggy d-44, the 2nd is a 10 bolt chevy front, and the 3rd is a 12 bolt chevy rear. and yes i searched, i fail at searching.

Grab a buddy and a tape measure, go from wms to wms ......:D

i dont have the axles here, im about 50 miles away from them, i dont want to buy them and have them be to wide or narrow.

I have a chevy 10 front a 12 rear and a chevy d44 front. I doubt the d44 measure will help but I can measure any if you like. Where do you want me to take the measurements from? Spring perch to perch? Hub Backing plat to backing plate? All?

WMS to WMS, and perch to perch, 10 and 12 bolt only

Im gonna say that the 10b front is 67.5" wms and the 12b is 65" wms.

i dont have the axles here, im about 50 miles away from them, i dont want to buy them and have them be to wide or narrow.

sorry, I promise I was NOT trying to be a smartass.....I will get you
some numbers...

Okay, I measured the ones I have laying by the shop and,

12 Bolt rear: WMS to WMS Approx. 62.75" (+/- .25")
center to center for the factory perches Approx. 42.50" (+/- .25")

10 Bolt front: WMS to WMS Approx. 64.50" (+/- .25")
center to center of perches Approx. 32" (+/-.25")

Of course, these numbers are just me and a little tape so I am APPROXIMATING
Anyway, hope this helps....

wow, that seams really narrow, i thought they where 69 each