I picked up a cheap dodge DRW dana 60 front with drive flanges, so I am guessing mid 70's to mid 80's as far as vintage. Has anybody ever swapped the inner shafts to set-up a driver's side drop 609?

Was hoping to use the inner shafts, Inner/outer knuckles, spindles, maybe the outer shafts from the dodge axle. I plan on picking up a set of 5 on 5.5 hubs with lock-out for the 30 splines. Plan on continuing to run my 35"s for a few more years. Eventually stepping up to 37-40's with 35 spline outers in the future.