Ok, well today I had an adventure I went to the river and almost got submerged. After about a half of an hour of winching I finally get it out. Then I had to take my plugs out to get the water out of the cylinders. Once that happened I let it run for about 5 minutes, then I noticed that the oil pressure gauge was not working. I turned off the jeep and came to the conclusion I do in fact have pressure. My question is where is the connector or pressure sensor located. I think it is wet and am going to let it dry out. Any pictures would be awesome.

-Alex

Need specifics. Year, model, engine.

Sorry Here it is:

03 Jeep Wrangler "X"
5 Speed
6cyl 4.0

If you had water in your cyl, there is water in your oil. Change it immediately and check all other oils too.
Travis..

If you had water in your cyl, there is water in your oil. Change it immediately and check all other oils too.
Travis..

you probably all ready fawked your engine up.