Looking at part number BRK-1063 for a 3.25" axle tube, radius arm with coil-over brackets. But not sure if they'll quite work.

What I need are these 3 dimensions

A- axle center-line to shock-mount center-line
B- axle center-line to lower arm-mount center-line
C- axle center-line to back of bracket at axle center-line height, got a tie-rod that I need to make sure will still fit.

Crappy drawing of what I'm talking about
http://i50.photobucket.com/albums/f306/maxyedor/bracket.jpg

[QUOTE]Radius arm mouting width is 2.5" and is clearanced for use with 2.63" joints as well]

I assume by that that the brackets have been milled out so a 2.63" wide joint (in my case heims with misallignments) will fit right?


Also, assume I order by end of business Tuesday, when should I expect them to ship?

A = 4"
B = 1"
C = 5.125" depending on how you measure it.