ijeepjeeps
09-29-2009, 08:06 AM
Having a baby in 5 months and need money to get some projects done ASAP.
Hare are the basics about my Jeep.
Drivetrain; 400 chevy small block, ford Np435 (4 speed with granny low) and Dana 300 transfer case. Axles are full width Dana 44 front and Dana 60 rear, 4.10 gears and the rear is welded. Has new rear driveshaft and the rear axle has a new u-joint and pinion yoke.
Suspension; spring over using 3.5 lift springs with stock springs mixed in to prevent sagging. Flexs like a champ. Has Rancho 9000 shocks (need replaced probably) I have a traction bar that prevents rear axle wrap, bought from Sams Off Road.
Wheels/tires; 39.5x15" Super Swampers....tread is decent. Rims are 15x10" beadlocks, has 18 bolts that old the outter lip in place. Tires are holding air even with not moving for a month.
Other; Interior is rough. The engine is stout, Edelbrock 750 cfm carb (needs tuned) The cam most likely needs replaced, back fires through card and cylinder #5 has a floating rocker. Not sure if the valve is stuck or what. I don't have time or money to mess with it. I would like to $3500 for, but I'm realistic and will listen to offers. I have pics upon request if interested, my phone number is 913-915-4485 or e-mail cpepper@recovercare.com.
Hare are the basics about my Jeep.
Drivetrain; 400 chevy small block, ford Np435 (4 speed with granny low) and Dana 300 transfer case. Axles are full width Dana 44 front and Dana 60 rear, 4.10 gears and the rear is welded. Has new rear driveshaft and the rear axle has a new u-joint and pinion yoke.
Suspension; spring over using 3.5 lift springs with stock springs mixed in to prevent sagging. Flexs like a champ. Has Rancho 9000 shocks (need replaced probably) I have a traction bar that prevents rear axle wrap, bought from Sams Off Road.
Wheels/tires; 39.5x15" Super Swampers....tread is decent. Rims are 15x10" beadlocks, has 18 bolts that old the outter lip in place. Tires are holding air even with not moving for a month.
Other; Interior is rough. The engine is stout, Edelbrock 750 cfm carb (needs tuned) The cam most likely needs replaced, back fires through card and cylinder #5 has a floating rocker. Not sure if the valve is stuck or what. I don't have time or money to mess with it. I would like to $3500 for, but I'm realistic and will listen to offers. I have pics upon request if interested, my phone number is 913-915-4485 or e-mail cpepper@recovercare.com.