ok y built a custum buggy ,

y need information , for my motor too pu on my transmission

have 1.6td vw pump 11mm , injector 261 , and some modification have more then 120 hp .. and y think so is ok for my setup .

and have automatic transmission 700r4 , have some modification on too , shift kit and more .. whill supose suport 400 hp ..

my question is , whow to put on my motor .. , y tink need to built adaptor plate to put in .. but what ring gear put in , they 700r4 ?

if any personne have this setup , please help me .. some picture ou site for my project . tanks

I truly hope that English is not your primary language.....

That being said....I don't think anyone has even done that, but I could be wrong.

you are probably looking at a custom adaptor. you might try advance adapters as they are known for swap and engine/tranny adaptors....otherwise, a good fab shop will probably have to do this.

You might be better off running the front wheel drive volkswagon tranny and mounting the motor so that the transaxles go toward the front and rear of the buggy and some custome half shafts serving as the driveshafts. This should be an easy setup since its a going in a buggy. As well, I'm pretty sure that VW trannys can be built up for racing use, but 120hp isn't goint to break it either.

tanks for your responce . and yes is not my primairi lang

for the tranmission of vw the ration is not good , and yam not sure if is good to lock the diferentien in the trany ... this trany is littel fefi