I am looking to get a down-pipe for my truck and was wondering if anybody knew of somebody that can TIG stainless for me locally? I can source the pieces but I imagine they could be had for cheaper through a proper exhaust place.

What I need done-
3" 2-bolt flange straight to 4" then a slight bend (maybe 15 degrees) and then about 2' of straight then a ~60 degree bend to a V-band flange

I can order the parts online but I am looking at around $450 shipped to my door and if anybody knows where I could do better that would be cool too. So... anybody TIG around here and if so, how much would it run to get something like this setup?

Thanks

i know two someones that can tig let me know if ur interested both of their shops are in chino

competition mufflers in Riverside next to norms..Steve is the man and will hook you up!

competition mufflers in Riverside next to norms..Steve is the man and will hook you up!


x2


It's on Hole ave near the intersection of Tyler and Hole.

Thanks guys I will prolly take it to competition