I'm finally to brake lines and I'm trying to find a thread with some information on putting together your lines and fittings. My 14 bolt is off a 83 GMC pickup. It has no plumbing what so ever for the drums. I'm going from a stock YJ MC to these rear brakes and wondering where I can buy the line, bender, and various fittings. I didn't have any luck talking with the chubby kid at autozone. Where have you guys bought your supplies from?

bring a wheel cylinder in with you, or have the kid at the zone pull one
then go to the bulk rack and see what one fits
what proportiante valve do you plan to run
m/c lines would be the same
zone napa and etc sell line benders and cutters
zone and above have brass fittings if you need to make the bulk lines longer
best advice
cut some scrap off the bulk and try to bend some 90 degree bends
you will see how the tool works

Anything brake related go online and call the guys at inlinetube.com. I got all my rear
14bff lines and fittings from them and they were very helpful when doing my 3/4 ton swap and the price was right for the quality of parts and knowledge they offered. shipping was less than a week to the left coast too.