Hello all,
I have searched and there is lots of info on Toyota boxes and such, and lots of info on tapping the aluminum caps on the saginaw boxes, but nothing on tapping the cast iron box itself?

Got pics? I was going to buy one from TheLakeRat, but he has none in stock and I need it installed by next week, so I need to do it myself.

Just picked up a box rebuild kit, and want info on where to drill and tap the box.

Thanks,
Phil Jensen

I have a 4 turn sag box that the lakeray made up for me about 6 months ago. I just made a mod that stops me from using it.
So I gues sI need to sell it.
Interested?


If not I can snap some pics of the hole locations and get back to you..

What do you want for it? What box? YJ?
I need a YJ box - don't want ot have to move all the holes around and stuff.

Also, when would it be avaialble?

I just picked up the rebuild kit, and was going to tear my box upo tongiht.




Phil

Donno what the bolt pattern is for a YJ perhaps someone else can help..

This is a standard 4 bolt inside the frame saginaw box. It was fited on a LC.
I was looking for ~$150 for the box.

Perfect condition, very few miles on it..

If it's the same as a YJ box and can ship out right away then I'm interested.
Anyone around you got a YJ box to compare? I have seen many different bolt patterns of saginaw boxes at the junk yard.

Phil

dude i have a box if ya want and i also know exactly where you need to drill and tap the hole for the ram.get back to me dude.
shawn

does anyone have a writeup on how it's done? I have seen the Yota how-to. Someone has to have pic on how it's down on a Saginaw