what happend to http://www.roggyenterprises.com ??

- jack

did you try www.roggyent.com ??

Edit: that doesn't work either but it used to.

Maybe he didn't pay Lance! Or is is a part of ShafferOffroad now since he is there all of the time.

NO TALKED TO MIKE JUST THE OTHER DAY NO JOINT EFFORT YET PROLY JUST DOWN RIGHT NOW:flipoff2:

I looked on Wednesday and couldn't find anything working, either. Oh well. :D

ok, it's probably just down.

I think Bob lives in el Dorado ... mapquest says it's 92 miles to Carson City ... that'd be a nasty commute ...

- jack

TRUE AND HE'S SETTING UP COURSES FOR CALROCS ALL WEEK TOO

I am heading up to Donner Si Ranch (CalROCS) in a couple of hours to practice my judging. I will let him know you are looking for him. Like he will run right to the phone:flipoff2:

Lance will know whats up, Bobs site is hosted on our server so I am not sure whats up?

i wanted to send him my passenger side dana 44 knuckle to get it drilled and tapped for crossover. if he is out of the picture, who else is doing it?

Originally posted by surlynkid
i wanted to send him my passenger side dana 44 knuckle to get it drilled and tapped for crossover. if he is out of the picture, who else is doing it?

Wagoner says about a week turn around time, Grady's (http://www.gradysoffroad.com/welcome.html) apparently has milled & drilled knuckles on hand, so he trades them.

If you find anything else, let me know. I called Avalanche, and the guy was clueless as to whether they do them or not, and he worked in the shop! :eek:

Bryan

BOB'S NOT GOING ANYWHERE HE'S BEEN AROUND FOR A LONG LONG TIME

Originally posted by Oxjockey
If you find anything else, let me know. I called Avalanche, and the guy was clueless as to whether they do them or not, and he worked in the shop! :eek:

Bryan

Yeah Avalanche does it. They don't machine the top of the knuckle to be perfectly flat though. I was kinda irked at that part when they did mine. If you do send them a knuckle make sure and designate that it needs to be 9/16" if you want to use the standard GM studs. They have switched all of their steering arms to use a 5/8" stud and conical washer. They'll tap it 5/8" if you don't specifically ask for 9/16". Mine was $50 and no shipping since I'm local.

he didn't pay his bill. ;)

Originally posted by Lance
he didn't pay his bill. ;)


Ouch! that's harsh! :evil: And he is a fellow Pirate no less.:eek:
( playing no favorites there....)

Eric