iheaps
12-13-2009, 12:17 PM
Hey all,
I have swapped out a set of Dana 44's from a '64 Jeep FC-150 with a set from a '79 Jeep Cherokee. While I was checking everything out after I set the frame back on, I notice that the camber is off on the front wheels. I don't know too much about this stuff. I do know that it is a positive offset and the difference from the top of the wheel to the bottom is about 1 inch.
I remember reading about an adjustment for the upper joint on the knuckles and did some searching. I found this website: http://www.jeepfan.com/projects/camber-adjustment.htm. Is this something I can do to fix the problem or is there something else I need to do?
I have swapped out a set of Dana 44's from a '64 Jeep FC-150 with a set from a '79 Jeep Cherokee. While I was checking everything out after I set the frame back on, I notice that the camber is off on the front wheels. I don't know too much about this stuff. I do know that it is a positive offset and the difference from the top of the wheel to the bottom is about 1 inch.
I remember reading about an adjustment for the upper joint on the knuckles and did some searching. I found this website: http://www.jeepfan.com/projects/camber-adjustment.htm. Is this something I can do to fix the problem or is there something else I need to do?