I am looking to see in you can install from the ball joints out on a 1999 and newer dana 50 /Dana 60 on to a 1994 Dana 60 housing, they are both ball joint housing. I have did quite an bit of serching but it looks as if no one has tride this.

Any help would be great.
Richard

When you did all your seArching, did you try searching for knuckels or KNUCKLES.

fwiw the upper ball joints are the same 94 compared to 00

interchange
Dodge Truck Ram 2500 3/4 Ton - Pickup 1994 - 1999
Dodge Truck Ram 3500 1 Ton - Pickup 1994 - 1999
Ford Truck Bronco 1980 - 1996
Ford Truck Excursion 2000 - 2005
Ford Truck F150 1/2 Ton - Pickup 1980 - 1996
Ford Truck F250 3/4 Ton - Pickup 1980 - 1997
Ford Truck F250 Super Duty 3/4 Ton - Pickup 1999 - 2004
Ford Truck F350 1 Ton - Pickup 1980 - 1985
Ford Truck F350 1 Ton - Pickup 1992 - 1997
Ford Truck F350 Super Duty 1 Ton - Pickup 1999 - 2004
Ford Truck F450 Super Duty 1 1/2 Ton Truck 1999 - 2004
Ford Truck F550 Super Duty 1999 - 2004

and the lower ball joint as well

interchange
Dodge Truck Ram 2500 3/4 Ton - Pickup 1994 - 1999
Dodge Truck Ram 3500 1 Ton - Pickup 1994 - 1999
Ford Truck Excursion 2000 - 2005
Ford Truck F250 Super Duty 3/4 Ton - Pickup 1999 - 2009
Ford Truck F350 1 Ton - Pickup 1992 - 1997
Ford Truck F350 Super Duty 1 Ton - Pickup 1999 - 2009
Ford Truck F450 Super Duty 1 1/2 Ton Truck 1999 - 2004
Ford Truck F550 Super Duty 1999 - 2004

and the axle joint as well

Ford Truck Excursion 2000 - 2005
Ford Truck F250 3/4 Ton - Pickup 1978 - 1979
Ford Truck F250 Super Duty 3/4 Ton - Pickup 1999 - 2008
Ford Truck F350 1 Ton - Pickup 1985 - 1997
Ford Truck F350 1 Ton - Pickup 1979 - 1979
Ford Truck F350 Super Duty 1 Ton - Pickup 1999 - 2008
Ford Truck F450 Super Duty 1 1/2 Ton Truck 1999 - 2008
Ford Truck F550 Super Duty 1999 - 2008

somebody send me some ford ball joint knuckles/spindles and I'll try it. I'll even document every step to see if they fit or where it goes wrong.

I have a 1995 f350 and just swapped from knuckles out from a 2000 F450, the pass side axle shaft from the F450 was longer but the u-joints were the same so i swapped inner axles and with some steering mod's due to the larger tie rods i'm driving the truck with F450 brakes up front and 19.5 wheels.

would need a set of knuckles to verify the fit and finish, but if this is the case, alot of the older unit bearing trucks can swap knuckles/spindles and go back to a wheel bearing setup. I know they are cheaper to replace every year than unit bearings.