|
Oxblood 10-01-2002, 05:06 PM I'm building a Dana 44 out of a 77 or 78 F250, and I need shafts, everywhere I've called says they need a BOM number but unless I am looking on the wrong side of the housing I can't find one. does anyone have any suggestions Mr.N 10-01-2002, 06:36 PM Get a wire brush, clean dead center front until you find numbers. You'll find a date code and something like: 610040 Is it high pinion? Have open or close knuckles. Oxblood 10-02-2002, 02:19 AM It is a high pinion with open knuckles, I found the number on the short side of the tube. but I figured it would on the long side, since every 44 I have seen has it on the long side. Oh well, I'm drunk right now, I don't know:p Mr.N 10-02-2002, 06:28 PM Originally posted by Oxblood It is a high pinion with open knuckles, I found the number on the short side of the tube. but I figured it would on the long side, since every 44 I have seen has it on the long side. Oh well, I'm drunk right now, I don't know:p So, what's the number? Anyways the 77.5-79 F250's do have different axle shaft lengths, so you need the BOM | |