I need to replace the joints in my re super flex lower control arms. Looks pretty straight foward just wondering if there is a preload or torque spec for the preload on the joint? I've serch hi and low for some spec but haven't had a luck. Has anyone else done these before? Any help would be appreciated :)

I would e-mail or call R.E.

Did this years ago, called RE, no torque spec, just told me to tighten hell outta them. For tha large I go until I can barely move the joint by hand, then align the set screw with an impact. I just use a little less torque but same procedure for the small ones. They've lasted years since, so I must have done something right. It's worth it to get the tool from RE for 'em...tons easier. For the bushing end, the Harbor Freight ball joint press works perfect.